Calibration

Follow

Gyroscope

Turn on the tracking accessory and connect it to NEON Personnel Tracker or Signal Mapper. Allow the tracking accessory to sit still for 15 seconds. The calibration will be applied when you turn the tracking unit off and back on again.

 

Magnetometer

Turn on the tracking unit and connect it to the NEON Personnel Tracker or Signal Mapper Application. Hold the tracking unit upright so that the power button is facing you. Rotate it 360 degrees about the Y axis, then rotate it 360 degrees about the X axis. The calibration will be applied when the unit is turned off and then turned on again.

This calibration is dependent on the environment, so if the calibration fails many times in a row try calibration in a different location.

Was this article helpful?
0 out of 0 found this helpful

Comments

Powered by Zendesk